This course will be of interest to electrical workers wanting to improve their bending skills, utilizing both hand and power benders.
Demonstration and practice will be provided in the efficient production of stubs, off sets, back-to-back and saddle bends using both EMT and RIGID conduit.
Instruction will also be provided for the development of segmented bends and concentric formations.

NOTE: 10” level, measuring tape, marking pens, safety glasses and protective footwear are required.

• Conduit Bending is an 18 Hour course.
• Please Note: There is a maximum class limit of 14.
• Weeknight courses take place from 7:00 pm to 10:00 PM with Saturdays from 9:00 AM to 3:30 pm.
• Weekend courses run 9:00 am to 4:00 PM Saturday and Sunday.
• The number of people registered in each class (in brackets) will be updated approximately twice a week. Check with office staff for exact numbers.
  
  
  

  Schedule

  
  
  

  Conduit Bending starts Tuesday September 29 and continues Thursday October 1,   Saturday October 3 and ends Tuesday October 6, 2009
  Conduit Bending starts Tuesday October 27 and continues Thursday October 29, Saturday October 31, Tuesday November 3 and ends Thursday November 5, 2009
  Conduit Bending starts Tuesday December 1 and continues Thursday December 3, Saturday December 5, Tuesday December 8 and ends Thursday December 10, 2009