This course will be of interest to electrical workers wanting to improve their bending skills, utilizing both hand and power benders.
Demonstration and practice will be provided in the efficient production of stubs, off sets, back-to-back and saddle bends using both EMT and RIGID conduit.
Instruction will also be provided for the development of segmented bends and concentric formations.

NOTE: 10” level, measuring tape, marking pens, safety glasses and protective footwear are required.

• Conduit Bending is an 18 Hour course.
• Please Note: There is a maximum class limit of 16.
• Weeknight courses take place from 7:00 pm to 10:00 pm with Saturdays from 9:00 am to 3:30 pm.
• Weekend courses run 8:00 am to 4:30 pm on two consecutive Saturdays.
• Daytime courses run 9:00 am to 3:30 pm on three consecutive days.
• The number of people registered in each class (in brackets) will be updated approximately twice a week. Check with office staff for exact numbers.
  

  Schedule:

  
  

  .
  Conduit Bending starts Saturday November 28 and ends Sunday November 29, 2009 both days start at 8am and run until 4pm.
  Conduit Bending starts Saturday December12 and ends Sunday December 13, 2009 both days start at 8am and run until 4pm.
  Conduit Bending starts Tuesday January 19 at 7pm and continues Thursday January 21 at 7pm, Saturday January 23 at 8am, Tuesday 26 at 7pm and ends Thursday January 28, 2010.
  Conduit Bending starts Saturday February 20 and ends Sunday February 21, 2010 both days start at 8am and run until 4pm.
  Conduit Bending starts Saturday March 20 and ends Sunday March 21, 2010 both days start at 8am and run until 4pm.
  Conduit Bending starts Saturday May 15 and ends Sunday May 16, 2010 both days start at 8am and run until 4pm.