This course will be of interest to electrical workers wanting to improve their bending skills, utilizing both hand and power benders.
Demonstration and practice will be provided in the efficient production of stubs, off sets, back-to-back and saddle bends using both EMT and RIGID conduit.
Instruction will also be provided for the development of segmented bends and concentric formations.

NOTE: 10” level, measuring tape, marking pens, safety glasses and protective footwear are required.

• Conduit Bending is an 18 Hour course at the Fort McMurray Training Centre.
• Please Note: There is a maximum class limit of 16.
• Weeknight courses take place from 7:00 pm to 10:00 pm with Saturdays from 9:00 am to 3:30 pm.
• Weekend courses run 8:00 am to 4:30 pm on two consecutive Saturdays.
• Daytime courses run 9:00 am to 3:30 pm on three consecutive days.
• The number of people registered in each class (in brackets) will be updated approximately twice a week. Check with office staff for exact numbers.
  
  
  

       (#Registered)                       Schedule:
  
  (0)             TBA